Pictures below of a Quarry Tiled floor that a customer had discovered when taking up the lino at her house in Coulsdon. Realising the floor was original and worth saving she contacted Tile Doctor and I popped round to take a look.
A lot of the tiles had been covered in a screed to provide a flat base for the Lino and that would need removing. In order to be sure what treatments would work to remove the screen and successfully restore the Quarry tiles without causing any damage I ran a couple of tests and everything seemed ok.
 |
 |
We could both see the job wasn’t going to be easy and would take some days to complete so I worked out a price which was accepted and we agreed a date for the work to start.
 |
 |
Removing Screed from Quarry Tiles
The Quarry tiles in the WC hadn’t been covered in Lino so they would just need a good clean and seal so the main work would be in the Hallway and Kitchen. Fortunately my customer was having a lot of other work done in the house and was in the middle of stripping the walls so I didn’t need to worry too much about protecting the skirting boards etc.
Working in sections I soaked the screed in water and then carefully chipped away at it until it came loose, it was slow work but I could see the process was working as expected and eventually all the Quarry tiles were revealed. There was still a lot of cement from the screed stuck to the surface of the tile so after sweeping up the chippings I set to work applying a strong solution of Tile Doctor Grout Clean-up to the tiles and leaving it to soak in for a short while. Grout Clean-Up is an acidic product that we normally use for removing grout smears from the surface of tiles. The solution was scrubbed in and then rinsed off with water and extracted with a wet vacuum.
 |
 |
To get the tiles in the toilet clean I gave them a good scrub with Tile Doctor Pro-Clean which is a reliable and effective Tile and Grout cleaner. Once clean they were rinsed with water and dried with the wet vacuum.
Sealing Quarry Tiles
I had timed my visit between working being carried out at the property so I was able to leave the floor for a few days so it could thoroughly dry out. I returned later to check the Quarry tiles were dry and completed the renovation by sealing the floor with Tile Doctor Seal and Go which is a water based sealer that works really well on Quarry tiles. Five coats of Seal and Go were needed to fully seal the tiles and the floor now looks transformed.
The owner was very satisfied with the improvements and before leaving I advised to cover the floor before starting the decorating work.
When cleaning sealed floors with a mop we recommend using two buckets, one containing a neutral pH cleaning fluid such as Tile Doctor Neutral Tile Cleaner and the second where you rinse your mop afterwards, otherwise you will contaminate your cleaning fluid with dirt.